Unable to update RatOs repo after branch change

Hello guys, I've tried upgrading my probe to unklicky and followed a blogpost which said to switch to develpment branch of RatOs.
After the branch change (an the change in moonraker.cfg to prefer dev branch) I got and "invalid" state for RatOs in the update manager.
I cannot recover from this state with either soft or hard reset.

Hard recovery log:
22:28:00 Cloning into '/home/pi/klipper_config/.config_repo_backup'...
22:28:00 fatal: protocol '
22:28:00 Git Repo RatOS: Git Clone Failed
22:28:00 Error Recovering RatOS
22:28:00 Git Clone Error

Ia there a way t o fix this without reinstalling the Pi image alltogether?

Thanks in advance!

KKodex1997 Hello guys, I've tried upgrading my probe to unklicky and followed a blogpost wh...

miklschmidt•6/2/23, 8:45 PM

Looks like you're on V1.. That blogpost is very outdated and i did not like the instructions in the first place, the development branch is for development, not for users. Stowable probes are natively supported in RatOS v2. V1 is not supported anymore (i gave people 3 months to upgrade from v1 when v2 was released earlier this year).

miklschmidt•6/2/23, 8:46 PM

I recommend downloading a copy of your printer.cfg, then use it as a reference when setting up RatOS v2. It should be pretty straight forward, a lot of things improved in v2 over v1. Just follow the installation instructions.

urgent-maroonOP•6/2/23, 8:46 PM

Ok perfect, i saved my printer cfg just be text editor before updating.
Thanks alot, i will upgade to V2