Z Offset not saving
Not quite sure why, but the past couple prints my z offset resets itself and i have to manualy adjust it while printing. I configured it with the command and it was good. i even looked into the printer.cfg and it was safed but after i started printing my first layer was really squished. the piece of paper was barely touching the hot end when i configured it.
8 Replies
check your filament gcode settings
sometimes there is a set gcode offset in it that could explain this
in the slicer ?
yes
Filament gcode
SET_GCODE_OFFSET Z=0
SET_PRESSURE_ADVANCE ADVANCE=0.05
that should be fine
i think
this
SET_GCODE_OFFSET Z=0should i delete that ? or type in a number
delete it
it sets your gcode offset always to zero
ah makes sense. not quite sure why it only happend now but thanks alot
so i switched to ratos 2.0 and now the problem with the z offset is back. im very confused. could it be a loose screw ?