Saddle Bed Mesh - V-Core 3.1 500
Hello Community!
My Rat V-Core 3.1 500 is built up so far to drive first tests.
The Mesh looks not that good. And hast a range of deviation of around 0.5 mm.
Printer Data: - V-Core 3.1 500 mm - SuperPINDA / Beacon
Printer Build Skills: Beginner, already saw the "Mark"-Video, but uncertain if this helps alone.
Please give me your advices. Thanks a lot!
Flow
6 Replies
flat-fuchsia•16mo ago
A few retries to get better result....
flat-fuchsia•16mo ago
flat-fuchsia•16mo ago
flat-fuchsia•16mo ago
Does anyone have ideas?
this looks to me like two issues - gantry has downward bow, y rails have upward bow. Given how symmetric the bow looks to be in Y, I'd suggest taking a look at your electronics panel and see if it is, in some way, pushing those rails upward and causing some bow...
some of this you may be able to dial out just by playing with the torque on the bolts holding your linear rails (both x & y)