Y limited to 3600
standard 500 vcore 3.1 . is there any way to get faster acceleration than 3600? what will happen if i set acceleration on the slicer to say 10000 ?
9 Replies
This is normal and your graph looks great
You might get more rounded corners and other imperfections. You could use this accel for perimeters and go higher on infill
The recommended shaper is ZV, so you can set the limit to 4500
belt tension to low
No this is normal for a 500 and increasing belt tension wouldn't increase the max accel by much
300 86-100 hz
400 66-75 hz
500 53-62 hz
recomandet ratrig
Yes that's the frequency the belt has like a guitar string, not your frame/printer resonance
can you elabarate please? you mean such frequencies can be checked by guitar tuning apps, not by adxl?
The Android app gstrings is pretty good for a first tune. Gantry in the middle at the back. But afterwards check belt match with the adxl
I usually do it by ear
If you can tune a guitar, you can also match belt tension by ear
My point was that the listed frequencies are not the x and y frequencies from the adxl. They are belt resonance. The adxl frequencies for x and y are very different. 40hz on y and 62 on x for a typical 400. If you tighten your belts to 65hz with the gantry at the back, you'll still measure about the same frequencies
evident-indigo•2y ago
Where do and how do I have to measure these values?