Octopus Pro H723 v1.1
I have ordered the updated Octopus Pro H723 v1.1.
@miklschmidt Is it possible to get supported also this version in RatOS?
https://github.com/bigtreetech/BIGTREETECH-OCTOPUS-Pro
GitHub
GitHub - bigtreetech/BIGTREETECH-OCTOPUS-Pro: This is OCTOPUS Pro o...
This is OCTOPUS Pro open source material. Contribute to bigtreetech/BIGTREETECH-OCTOPUS-Pro development by creating an account on GitHub.
12 Replies
* take https://github.com/Rat-OS/RatOS-configuration/tree/v2.x/boards/btt-octopus-pro-h723 and copy to new folder renaming it btt-octopus-rp-h723-11
* change the references within that folder to use
btt-octopus-rp-h723-11 instead of btt-octopus-rp-h723
* update config.cfg with new pin changes
then submit a pull requestconscious-sapphireOP•2y ago
I never did that kind of staff. Could You help me with that? 😊
Done!
Also merged! 🙂
conscious-sapphireOP•2y ago
Thank You so much 😊👍
desirable-aquamarine•2y ago
Hi, I'm having issue setting up my new BIGTREETECH Octopus Pro H723 V1.1. Despite the fact that it is listed in the http://ratos.local/configure?step=1 the compile button seems to be doing nothing. I think that the issue is that the .sh files in the folder are not executable. On top of that firmware.config is identical to the non v1.1 version - at least CONFIG_USB_SERIAL_NUMBER should be with "-11" at the end I think. Finally the control board should be added also to the printer.cfg. I might be missing also something else...
Did you update RatOS in mainsail before trying?
Oh something is strange, there's a H723 and a H723-11
lemme see what's going on
I think i merged a pull request that duplicatecated that board. The h723 was already supported.. I'm deleting the -11
done. @tsvetomir8097 please go and update RatOS in the mainsail machine tab, and the -11 duplicate should be gone. You should use the "Octopus Pro H723". Thanks for reporting!
Oh, now i'm realizing it shouldn't have been removed 😂
Fixing.. jesus..
Once again, i blame the morphine
There we go. Now it should work properly. Confirmed the pins were fixed and that the firmware is compiled with the correct chip id. Also fixed permissions on the .sh files and added it to the templates. Please update and give it a shot @tsvetomir8097, apologies for my surgery induced confusion 
desirable-aquamarine•2y ago
@miklschmidt Thank you very much! Seems to be working correctly now.
Excellent 👍
desirable-aquamarine•2y ago
Oppps sorry @miklschmidt seems confirmed a little bit prematurely. In printer.cfg templates you have added "-11" on wrong place "....-octopus-pro-h723/config-11.cfg" but should be "...octopus-pro-h723-11/config.cfg"
Oh my god i'm a moron
Will fix that
Done! 🙂 Thanks for the sanity check! 😄
desirable-aquamarine•2y ago
No worries - thanks for your invaluable support and commitment!
You got it! 🙂