10 Replies
I have a Fabreeko edge to edge heater with a 3950 thermistor
The Printer has been fine for several months, no issues.
I started to get this error after enclosing it and attempting to print ABS
Initially I had several 2+ hr prints go well
And then Started to error randomly during prints (between 20mins and 2hrs into a print)
I have done a fresh PID tune at 100c for the bed
Also have been trying to insert and play with these values. I'm not even sure i'm on the correct path here
I never had intentions of printing ABS on the V-minion but my prusa is down at the moment and am trying to print the parts for my upcoming enclosed V-Core build. If I can't this sorted I'll be having to order printed parts.
And the Build of this V-minion is from the RatRig kit. the only parts that differ are a Revo hot end and the Fabreeko edge to edge bed heater.
upload your entire printer.cfg
Anyone got any ideas?
lines 31-41 should be moved to the user overrides section
get rid of the
verify_heater stuff
change
to
otherwise I would do a general check of your wiring to ensure nothing is loose or broken
if it still is having issues, I would contact Fabreekoalright, thanks
It's got to somewhere in the hardware. I checked connections in my electronics box and reseated them just to be safe (though they were solid as is). Just now printing some petg to test things out I had the same error. I do have the standard bed heater that came with the kit so may be swapping over to that.
-replaced my bed heater
Power delivery is drastically different now lol
