VFA after 3.1 upgrade
No matter what I tried I can't find the problem. Any ideas?
6 Replies
I had similar issues after an upgrade 3 to 3.1 on a 500. Turns out I had way too much tension on my belts.
adverse-sapphireOP•2y ago
Got it, I will check that
After belt tension checks and input shapper activated, I run an accel test to select the optimum balance between X and Y accels that are given by input shaper. This accel I find is my outer perimeter accel. https://www.klipper3d.org/Resonance_Compensation.html#:~:text=before%20enabling%20it.-,Selecting%20max_accel,-%C2%B6
@tom.cruise did you ever figure this out?
adverse-sapphireOP•2y ago
Seems like the belt was too tight
I'm validating it know
Ya less belt tension did the trick
Good to know. Thank you. I think I have the same issue