TMC 'stepper_y' reports error GSTAT: 00000004
This is my first V-Core Build and RatOS configuration. I went to print a calibration cube and about 25% ish in the print failed.
Klipper reports: SHUTDOWN TMC 'stepper_y' reports error: GSTAT: 00000004 uv cp=1 (Undervoltage!)
I linked the klipper log, printer.cfg, and screenshot.
4 Replies
Looks like some layer shifts as well.
do a search for GSTAT: 00000004 LOTS of responses on this very issue
I can look into making sure the connectors are inserted entirely and replace it with a backup driver.
Replaced EZ stepper driver, and was able to print a calibration cube but the following print it failed w/ the same error. I'll look into shortening to run and crimping on new pins.
Did that help?