Cracking sound during Z Tilt
I’m hearing what seems to be like a cracking sound when I home Z. Initially I forgot to tighten my nozzle and I’m almost certain that it was the cause —pushing up the printed parts.
However after I tightened it, and homed (without any issues). I did Z Tilt, BLTouch registered fine in the front left probe point, toolhead traveled to the back center & failed “no trigger on probe after full movement”. At that point it seemed to make the cracking sound again but I’m certain it wasn’t from the pressure coming from the nozzle as it was tightened. Im pretty certain I cracked the heat sink / fan shroud petg parts when installing the nuts initially but everything didn’t budge and I was going to reprint them in ASA immediately anyways. Is the EVA system the first place to check? V-Core 3.1 & Enclosure 2.0 for reference.
0 Replies