Z_TILT_ADJUST - Impossible to complete.
Hello. since 5 hours I can't handle both with Z_TILT_ADJUST
I checked everything I know, even changed all possible motor connections to Z, Z1, Z2,
LMR
RML
LRM
pe
MLR
MRL
in the first combination the difference goes down but around 5-6 it starts to grow??? and I got the error Retries aborting: Probed points range is increasing
log in the attachment
18 Replies
check if your motor couplers are tight
or if the ball screws on the bed are loose
or if your probe is loose
...
also, check with stepper buzzer if the z steppers are connected in the right order
check if your motor couplers are tight - checked
ball screws on the bed are loose - Checked
your probe is loose - Checked
STEPPER_BUZZ STEPPER=stepper_z2 not working - i changed the cable, changed tmc_2209
But motor moves on Z homing
metropolitan-bronze•2y ago
switching the left and right cable worked for me 🙂
I tried every combination of cables and it didn't work
you you need to make sure that all your steppers are in the correct order, not jsut swapping cables and hope the best
Stepper_buzz stepper=stepper_x
top left stepper
Stepper_buzz stepper=stepper_y
top right stepper
Stepper_buzz stepper=stepper_z
bottom left stepper
Stepper_buzz stepper=stepper_z1
bottom rear stepper
Stepper_buzz stepper=stepper_z2
bottom right stepper
first do this, then come back
you execute that command and feel with your finger directly on the motor pulley if the correct stepper buzzesOK
on x motor moving
on y motor moving
on z left and right they move synchronously and simultaneously
on z1 back motor are moving
on z2 nothing moves nothing happens
left and right should not move simultaneously
have you maybe connected on of these steppers to a slave stepper connector?
please show a photo of your board with the stepper connectors
probably not because I don't even know what you're talking about
here is my printer config
show me a photo of your board with the stepper connectors
i see the problem, you did not followed the ratos instructions
one of the oictopus stepper connectors is a copied conector
zoom into the photo
just dont use connector # 4
its a copied signal from connector # 3
now im see
nexxt time if you ask such questions itt would be good to tell the people you are not using RatOS
i highly recommend to connect everything as described in the ratos doku
and to use ratos ultimately
it makes your life so much easier
OK, will check this, and thank you for support
its works , thank you very much