Infill not connecting with outer wall
I had this problem before on my ender 3 and I fixed it with a setting in prusaslicer, but I can't remember which setting it was.
8 Replies
What is your infill/perimeters encroachment set to on SuperSlicer?
@robeenashepherd 25%
I have mine set to 45%, see if that helps you
will try that out thanks alot. first time using superslicer so I'm not really familiar with the settings XD
there are lots! It's all very daunting!
yeah it really is. I'm going to take a closer look tomorrow at all of them.
It is hard to understand what some of them do, but even harder to know the ones that you need to change and should change to fix the problem you are having. Thankfully I just fixed the issue you've had this week so that's why I know what setting it is 😂
oh yeah reading through all that is not going to be fun. guess I'm lucky XD