Calibration print with 0.6mm nozzle
Hi - which setting do I need to adjust to have the infill closer to the wall? This is my first calibration print with BambuStudio using a new 0.6mm nozzle. I have reduced the wall count from 3 to 2 but in would think there should be more overlap - right?
6 Replies
more people using SuSlic3r here than BBS.....hard to tell
unwilling-turquoiseOP•2y ago
Thanks - for me the solution was to set 'Infill/wall overlap' to 95%. Not sure why this increases so much from 25% with a 0.4mm nozzle but all good for now.
Have you changed the nozzle size in klipper to 0.6? this looks like it's under extruding
could be the PA value as well
Yeah that's hiding the problem with a new problem, not the solution
Don't judge under or overextrusion on layer one, z offset has much more impact there. Probably a missing zero in PA or forgot to change nozzle size in both slicer and klipper
unwilling-turquoiseOP•2y ago
Hi - it was the PA value indeed... I just set the infill/wall overlap back to 30% and the print results are still OK. I did the PA tower after the flow test and the picture above is from the BambuStudio build-in flow test. At the time I had the old value from the 0.4 nozzle which is much higher. Thanks.