mosquito hotend verify heater problem
I just installed a mosquito magnum hotend and upgraded it with the slice 50w heater and rtd1000 thermistor. I've configured it for the thermistor and can't configure the heater. I can't find the heater settings in the printer files nor do I know what to set them to. the heater doesn't heat over 340 and also takes about 5 minutes to get to that temp and then I get the error. I can't find any info on it the only thing I changed for the heater was the max temp not sure how to do anything else
7 Replies
What are you trying to configure about the heater?
conscious-sapphireOP•2y ago
it doesn't heat to 500c
it heats to 340 then I get an error heater not heating at expected rate
That's not a configuration issue
conscious-sapphireOP•2y ago
hi ive just put another slice 50w heater cartridge in and its doing the same thing. when i put the supplied 60w heater supplied with the rarig mosquito magnum it doesnt throw an error. i want to print at higher temps. i personally feel its heating slower than its supposed to. i have the boron nitride paste on the hotend. max temp is set to 450 i dont know what else to do
* 50w heater is very low
* Because of the design it is easy to cool off the hotend when you turn on the part cooling fan
* you will have to insulate the hotend to reach those temps
* even if you reach that temp, are your EVA parts going to survive?
conscious-sapphireOP•2y ago
ok i have a sock and right now im just upgrading for the future
do you reccomend a heater for the magnum
I would talk to Slice for that