Correct g-code flavor for prusaslicer and klipper?
I first used
Marlin (legacy) but it didn't give layer information and it seemed to run slower than it should. I then tried Marlin 2 but I keep getting these errors in the console: Invalid M204 command "M204 P1000"
I am planning on trying Smoothie next, but I am wondering what other people are using for the g-code flavor when using prusaslicer and klipper?4 Replies
adverse-sapphire•2y ago
Uh.."klipper" gcode flavor? Though that's in superslicer, does PS not have that option?
Correct, that's not an option...
adverse-sapphire•2y ago
That is unfortunate
wise-white•2y ago
create a macro for m204