Initial Homing
Hello all.I managed to finish my wiring (test fit to check that everything works).
So the problem is that i cannot home Y.When i press home all, it homes X successfully and then tries to home Y and it goes front right instead of back left and hit the front extrusion.
If i test with SET_KINEMATIC_POSITION the Y moves correctly...Any ideas???
VCore 3.1 with Octopus Pro with TMC2226 (but i dont think it matters)
2 Replies
https://docs.vorondesign.com/build/startup/images/V0-motor-configuration-guide.png
You match the bottom left in the picture. So you need to physically switch the A and B motor connections (remember, with a core XY both steppers are used to move in the X and Y, so both motors need to be correctly setup)
flat-fuchsiaOP•2y ago
Thanks!I swapped everything and tested every possible combination and i found out one of the TMC2226 acting strange.I had a spare and change it with a new one and problem solved....