Bridge not connecting
Working on tuning my bridging and I have it looking decent so far, but I see on this print the initial bridge line isn't connecting all the way to the other part of the print, I did a test of it and observed it indeed stops before it gets to anchor onto the other side.
Anyone ever observe this in SS? Other prints with multiple lines of bridging on the same layer don't behave this one, perhaps it's because it's just 1 extrusion width at first?
6 Replies
Here's my SS profile, this is with PLA
Also so photos of my config rn
I also notice that the line is considered an Overhang Perimeter and not a Bridge. I'm messing around with my settings but I can't get SS to recognize this line as a bridge.
deep-jade•2y ago
Turn of thin walls and try again.
Took me ages to find that
Im using Arachne for slicing so thin walls isn't an option
But when I uncheck arachne and do thin walls it doesn't even detect that it's a bridge.
I ended up using a rectangle modifier in SS to make the one perimeter into 2 and it bridges perfectly now. Seems like this is an issue with how SS handles a single perimeter bridge.