z probe issues
Hello all,
I've been printing now with my RR 500 for a couple of months now just fine. But a strange z probe issue has shown up. I kicked off a print but it stopped after homing all because after it did the z, the super z probe was still triggered. I read that this can happen when there is a break in the cable or connection to prevent damage. I don't use zip ties on any cables coming out of print head. I've checked connections on board..nothing has mad a difference. I had a spare super in the bag brand new, not opened, didn't attach to printer, just plugged it into the board. I ended up with the same result as the original. Am I now looking at a problem with the board? The board is a 466
Thanks
Jim
4 Replies
constant-blue•2y ago
have you confirmed that the wires are not broken at all? You can use a multimeter to confirm the wires have continuity
you can always connect it on other pins if you declare them properly
like-goldOP•2y ago
Yea, when I hooked up the brand new backup z probe I didn't attach it i just hooked it up and got the same exact results.
constant-blue•2y ago
So you just hooked up a new one but didn’t check your wiring?