Z-probe status is always triggered
Hi, again.
I searched the archive and found this https://discord.com/channels/582187371529764864/844167067757182980/1002023719989936228
Similar problem, but the good thing is my probe works, it lights up with a red LED and reacts to magnetic metals when I put them under it.
I also tried inverting the status on the
printer.cfg but the same issue, it's just showing open all the time.
4 Replies
Did you try all the various probe pin configurations? https://github.com/Rat-OS/RatOS-configuration/blob/master/templates/v-core-3-printer.template.cfg#L202-L205
GitHub
RatOS-configuration/v-core-3-printer.template.cfg at master · Rat-O...
The RatOS modular klipper configuration. Contribute to Rat-OS/RatOS-configuration development by creating an account on GitHub.
correct-apricotOP•3y ago
Hey @blacksmithforlife , thanks for the fast response!
I only tried these two.
I would try all of them. If none of them work, then double check your wiring with the probe's wiring diagram
correct-apricotOP•3y ago
Ha! The 3rd config works! I don't understand why, that config should not work with the spec of this probe.