inaccurate Y axis
so I just finished the build phase of my 400mm v3.1 and I'm running some of the basic stuff after configuring the basic printer.cfg. When I home all axes, everything appears to work properly except that when mainsail says y is at 200 its actually at 100. x and z seem to be working fine. When I try to probe for a mesh, it will start at 0,100 instead of 0,0 and then it hits the end of the bed in the y axis when it thinks its only at y=300
Does anyone have an idea if this is a build issue or a printer.cfg problem? I can't think of why it would be doing this at all. (its a 400mm build and yes I have it set to that in the printer.cfg)
4 Replies
Can you upload your printer.cfg please
foreign-sapphire•2y ago
Line 179 should be uncommented. Basically you have your config saying your Y endstop is at Y 300 which is why you're off by 100mm
foreign-sapphire•2y ago
well I'll be, didnt even see that
thank you!