TMC5160 Chopper Settings for 36V
Dear all, are there some special chopper settings (TBL, TOFF, HEnd, HStart) for a "normal" TMC5160 running at about 34V (because 35V is the mosfet limit) - or sholud i Just take the 24V/1,6A setting? Thanks and BR, Volker
6 Replies
sunny-green•2y ago
Check marlin config files, there are already settings tuned for that configuration.
national-gold•2y ago
Thanks a lot - I'll do 🙂
sunny-green•2y ago
i have the settings for 24v ,they work pretty well on my SKR PRO V1,2 and btt TMC5160 V1.2, if you wont tell me.
national-gold•2y ago
Dear Paulo, sorry for the late answer - got serious troubles with the 5160 😦 burned down my Octo-Board and just got a replacement yesterday .... sorry I'll try as sonn as everythings running smooth again.
sunny-green•2y ago
Hi, i get the same problem, i burn my fystec 5160qv too, replace with btt 5160 pro , and now the printer runs smooth and for my surprise i was getting some resonance at 100 mm/s, and now its so smooth.
national-gold•2y ago
Really - strange thing. I had the "surprise" with BTT5160 - wanna have them because of the same issue you have - some resonance around 80 - 120 mm/s of printing speed 😦 Tried changing motocable pinout - nothing. Yeah maybe I'll go for the PRO's too .... in the future.