new minion
so, i got this minion partially setup, everything is tight on y axis, no bed yet, no wires either but the Y resonance graph is a mess. this is the simplest belts path possible . what am i missing here ?
3 Replies
Can you hear something that vibrates? Could be the table, psu, screws, cables…
It’s also a quite low level, but that could also be due to the low weight
How tight are the belts (they should just as tight as they need to be to not slip during resonance measurements)
looks like the wire loom
there actually seem to be like no vibrations because its 1e3
1e3 is very good
no 1e3 is pobably bad.
it is more likely that you have too much friction somewhere and the shaper test cannot move the bed enough to get it to resonate. Or the adxl isn't picking up the vibrations because it is not attached to the bed well
oh wait, you have no bed mounted. That probably means it is so light now that the resonance frequencies are outside of the test range