warping with petg
Randomly in the last few days I have been getting warping with petg on my minion, I’m using standard configs with Prusa slicer and the room doesn’t have any cold air coming through. No idea why this is now happening
5 Replies
wee-brownOP•2y ago
It’s polymaker petg and I’m using a 4028 fan at 20% which has always worked fine
Is your house now colder? I noticed now that it is winter I am getting intermittent under extrusion unless I bump up my normal temp by 5⁰
wee-brownOP•2y ago
It is now colder but I sometimes have a heater on in the room and I get the same issue
Same issue with multiple different prints
The bed is properly cleaned?
wee-brownOP•2y ago
Yeah
It seems pla works fine, petg or abs doesn’t which makes me think the steel sheet is the issue
The other side is bare so I might just put painters tape over it
Just to confirm water isn’t really good with the textured sheet right?