Messed up infill.
for some reason my infill is looks like its not extruding fast enough, but every other feature is printing just fine. the infill is even printing a bit slower than the perimeters and the solid infill (170mm/s vs 180 & 200mm/s)
any idea why this happens?
4 Replies
what's your infill line width? it looks like you might be using 0.4, which is too narrow for single walls
try 0.5 at least
you can check the flow and speed in the slicer preview
ambitious-aquaOP•3y ago
flow is even all across the print at 10.3.
and the infill width is at 0.36 (arachne perimeter on) but this effect only happen when I print with cubic infill. Im currently printing something with grid infill and it looks just fine.
why 0.36? if you have a 0.4 nozzle and are extruding 0.36, how do you expect the line to become thinner if there are no adjacent lines? The only effect will be not squishing against the previous layer and no layer adhesion
I think i have actually had the same issue. Wider infill should work. Ill check it and give it another run.