Minion Working fine Now motor error
how can i correct this?
Klipper reports: SHUTDOWN
TMC 'stepper_z' reports error: DRV_STATUS: 001900d0 s2vsa=1(LowSideShort_A!) ola=1(OpenLoad_A!) olb=1(OpenLoad_B!) cs_actual=25
Once the underlying issue is corrected, use the
"FIRMWARE_RESTART" command to reset the firmware, reload the
config, and restart the host software.
Printer is shutdown
just happened today, all else was working fine
17 Replies
It is saying it has a short. Double check your driver's are seated properly, and double check all the wiring to the steppers
adverse-sapphireOP•3y ago
Thank you i will
all is good
odd
ive tried a new cable, heck ive even reloaded the printer config from scratch, like a new install @blacksmithforlife
Well something is causing a short. So check all wiring again
adverse-sapphireOP•3y ago
Replaced the board and all drivers
After installing v minion config it is stuck here
adverse-sapphireOP•3y ago
@blacksmithforlife
adverse-sapphireOP•3y ago
After swapping pis and boards
adverse-sapphireOP•3y ago
This is ver. 1.2.4 previous pic 2.0.4 alpha
Back up, did you install the firmware and do all the necessary configuration?
adverse-sapphireOP•3y ago
Of course , this is my third printer not my first
Got to cover the basics, many people miss those steps
adverse-sapphireOP•3y ago
Im with ya
I ordered a new board , the “new board “ i had had dim led lights
Did you work through all the steps in the pinned message?
adverse-sapphireOP•3y ago
New drivers 2209 v1.3
adverse-sapphireOP•3y ago
I have 2 pis a 3 and a 4 both no lick
All of this was previously working
I have to wait for the new board
Well you changed PIs and board, so you can't just swap things around like that and expect it to still work
When you replace a main board you have to reinstall the firmware, but before you can do that you need to recompile the firmware.
adverse-sapphireOP•3y ago
Yes all that has been done in order
I think the “new” replacement board is bad at this point
The old board lights up new one does not
Got this fixed , bad board.