probe override

I modified the probe override in the printer.cfg for the vzbot toolhead but still gives me same probe location points - and for the bed mesh gives me error out of range !
No description
13 Replies
blacksmithforlife
upload your printer.cfg
xenial-black
xenial-blackOP3y ago
blacksmithforlife
why do you have positive offsets for your probe when it is located on the left of the toolhead?
xenial-black
xenial-blackOP3y ago
Is located on the right and back of the hotend
xenial-black
xenial-blackOP3y ago
No description
blacksmithforlife
you sure the values are correct? Y is double the X value, but from your photo it looks like Xshould be the larger value
xenial-black
xenial-blackOP3y ago
This value come from VZ print head instruction
xenial-black
xenial-blackOP3y ago
No description
blacksmithforlife
what is the full error you are getting?
xenial-black
xenial-blackOP3y ago
No description
xenial-black
xenial-blackOP3y ago
And with a Z-tilt probe points not on the correct location
blacksmithforlife
I believe it goes to the XY point of the nozzle and just uses the offset for calculation That move out of range looks like it is after doing the bed mesh?
xenial-black
xenial-blackOP3y ago
I just CAD the mount like the Eva one - i think was too far away - thank you for the support
No description

Did you find this page helpful?