Afuevu
DIIDevHeads IoT Integration Server
•Created by Afuevu on 1/8/2025 in #🟩-pcb-and-analog
Developing a Motor Controller for an EV Two-Wheeler: Suggestions and Design Tips Needed
I started designing this motor controller and using stm32f103c8t6 and bare metal to set up the registers, I started up with generating 3 signals which are 120 degrees apart, my scope only has 2 channels so I couldn't have the 3 channels on the scope. If I had known when purchasing the scope I would have just gone for 4 channels.:8637blabbering: I had to send the signal through a low pass filter(no calculation was done, which I have to do) and that is what is observed on the scope, I am going to hook it up to Mosfet driver TLP350 and send the signals to drive the mOSFET.
2 replies