Using V-core 4 hybrid, have problems with my prints

Have problem when printing, some disturbance in my prints, I did all pře print setups like beacon calibration, belt tension, shaper graphs. It's probably something trivial, I am just stack on what it is:).

TheTik•4/20/25, 12:50 AM

Is that PLA? And did you double check that you're using a 0.4 nozzle?

cdorety•4/21/25, 8:38 PM

could be wet filament? or just bad filament. I had a spool of hatchbox PLA that turned out to just be completely unusable. My prints either failed, or looked similar to what you have there.

ChatGPT-anon-botOP•4/25/25, 12:49 AM

Using 0.2 nozzle, set it in setting to be 0.2. Used with Pla, Petg, Asa, Abs