Need help with resonance
x graph i believe looks alright but the y graph is vibrating much more than x and also speeds are super slow i assume. I am new to this type of stuff so maybe someone could help me fix the issue or tell me what might be the issue of this happening?
also tried this after these graphs but the code just wont work then and printer is disconnecting. any tips?🥲
[input_shaper]
shaper_freq_x: 61.0
shaper_type_x: mzv(61.0 Hz, vibr=0.0%, sm~=0.05, accel<=1700)
shaper_freq_y: 24.6
shaper_type_y: mzv (24.6 Hz, vibr=3.7%, sm~=0.34, accel<=1700)
3 Replies
Not sure about the graphs, but for the code, but its must mzv for type. I don't think you need that extra information.
x graph i believe looks alright but the y graph is vibrating much more than x and also speeds are super slow i assume. I am new to this type of stuff so maybe someone could help me fix the issue or tell me what might be the issue of this happening?
Try this
[input_shaper]
shaper_freq_x: 61.0
shaper_type_x: mzv
shaper_freq_y: 24.6
shaper_type_y: mzv
That worked for me. Furthermore, how tight are your belts? When you look at the y axis of your graph you can see 1e4 which means the density x 10000. I know my graph was at 1e6 . Maybe it could help to tighten your belts
i changed something and the code but print is still just so bad.. like first 2-3 layers are good and after it just goes crazy and fucks everything up. since nozzle head is 0.6mm maybe elevation also should be higher or no?