Dialing in ABS Settings
Im currently trying to dial in my settings on Hatchbox ABS. My bed temps are at 100C. Nozzle is at 225 for the first layer and 220 for the rest. Im fairly happy with the left side of the benchy but the right side seems rough. Im not sure if this is because of how the benchy is layed out in the slicer. The side that is rough is facing towards the back of the printer. Im not sure if I should continue to crank up the fan speed or lower the nozzle temp. I also attached my fan speed settings.
3 Replies
220 sounds way too low for abs
standard for ABS is more like 250
I kinda figured 220 was pretty low but that was in the temp range stated in the spool. I’ll try to print at a higher temp then report back.