Z offset isn’t always the same
My z offset is after every print gals again
13 Replies
@Helge Keck so here is the thread
How can I reset the complete z offset things also the thermal expansion
set the multiplier value in the ratos.cfg file to 1.0
delete all beacon models from the printer.cfg
then redo the beacon calibration
Where is it can’t find it
Ah ratos searched in printer.cfg
Okay can’t find it
Does it make a difference if I choose the rapido but have the chube installed ?
its in the file ratos-variables.cfg
Ahh okay
Then while printing the first layer and I do babystepping should I do save_z_offset in the Konsole or do I press the save button on the dashboard ?
in dthe console
while printing the first layer
Is there a possibility to set the z offset for the pei plate to -0.01 so I can easily change the offset if I need to ?
you mean having different z offsets for different build paltes?
you can use a gcode command to do that,
SET_GCODE_OFFSET Z_ADJUST=-0.01 before the print starts
you can also make a macro button that does that for youSo I type this in and then start the print or
yes
Ah okay and if I want this always so not a new thermal expansion just a little offset ?
Can I write this to printer.cfg ?
i dont understand
if you want always a offset change your toolhead offset
do it with the first layer tuning