Issue with beacon_calibrate
Hi everybody, I assembled the V4 500 idex and follow the commissioning guide. At the step "BEACON_INITIAL_CALIBRATION", the monitor returns that the command is unknown... Also, ath the begining of this guide, I founded that my "printer.cfg" file wasn't as big as shown. It doesn't contain sa many lines and I didn't have the commented section "SAVE CONFIG" Can somebody help me please? Thanks a lot....
33 Replies
Can you drop your debug.zip in here?
sure, Here you have
You're using 2.1, I think you're looking at a printer.cfg from ratos 2.0. this one seems fine
BUT, it is odd that you're getting an "unknown command" error when trying the beacon calibration. Still poking around
Thanks in advance. I tried several time to reflash the raspi and I always have the same problem at thios step...
I'm not seeing the error, but I'm not practiced in looking at these logs. Can you screenshot the error message?
kk, that does look spelled correctly
When you updated ratos did you just press "update all components"?
No, I first made the ratos and ratos-config as written in the guide
and after the "update all"
so strange.
Can you ssh in and run
ratos doctor?I try
We ran the command ratos doctor but nothing seems to be wrong
(we are working togheter)
Okay. When you went through the configurator, you selected the beacon as your z probe, right?
in setup wizard?
yeah
I check
here?
Look like this should be the mistake?
Yes, looks like you have the superpinda selected and not the beacon. That would do it!
I got a warning now
I can't see the warning
I click on "review changes"
DO I need to accept like this?
Yes, you need to accept the changes
ok!
It works....
THANKS A LOT
hooray!
thanks
Very welcome. Please mark this as solved 🙂
Done 😉