I accidentaly took out the metal sheet on top of the bed when I was trying to put axes to home
I am already trying to print the 3d parts that are broken, What steps should i do next?
15 Replies
HA! I did that exact thing myself
heyy @TheTik Tik!
I only broke one of those bearting holders, but it printed it's replacement fine without it
hahaha i figured out the adxl but then this happened lmao
hows it going man haha
The bed being out of "level" doesn't matter
got it
Turn the z screws by hand to get it fairly flat, z-tilt will figure out the rest
should i be worried about the shaft being bent?
I didn't notice it bent, see what happens is my feeling. The screw just moves the bed up and down, it is the z-rails that keep it on track
It might be bent more than the coupling can handle, I'd print without the top bearing thing and see how bad the top wobbles
If it's only a mm or two, then put the bearing thing back on and see if it prints. Only then if it starts to bind would I get a replacement
ok ill go on ahead and try that
im printing the parts i broke now
good luck, and let us know what the results are 😄
@TheTik bro can i send u a dm
Hello.
Are you homing without the steel bed plate on top?
That was the mistake called out in the title of the post, yes
Stupid blind 😛