Smart sensor always showing empty, even though the LED switches to green just fine

Hey guys, been setting up my Orbiter Smart Sensor yesterday, made all the connections fine, it also did work yesterday with PETG. Now today I decided to swap to PLA, and since then, the lights on the Sensor are Green with filament, Red without, unloading and tangle also both work. On the Mainsail interface however, the sensor now shows as always empty, is there any files where I can see if its actually transmitting data to the mainboard?
Thx

Solution

somehow switching PB3 and PB4 in the config did the trick

Jump to solution

TheTik•3/3/25, 6:51 PM

Could check with a multimeter

AlextankoOP•3/3/25, 6:53 PM

just discovered another funny thing

AlextankoOP•3/3/25, 6:53 PM

when i press onto the ptfe to make it simulate a clog, it temporarily turns to detected

AlextankoOP•3/3/25, 6:54 PM

after releasing, its empty again

TheTik•3/3/25, 7:01 PM

sounds like a config issue then. I haven't set one of those up though, not sure what to check

AlextankoOP•3/3/25, 7:02 PM

Solved it

Solution

Alextanko•3/3/25, 7:02 PM

somehow switching PB3 and PB4 in the config did the trick