7 Replies
I cant move my z axis. Instantly have this error and reset
With everything powered down, maybe unplug and replug the that stepper driver?
Maybe jumpers, maybe a bad driver, maybe a bad cable, maybe wrong port on the board, it can be a lot of things
You can test each motor with
stepper_buzz stepper=stepper_z
stepper_buzz stepper=stepper_z1
stepper_buzz stepper=stepper_z2
They should move the bed a bit down, a but up, stop and repeat this process for 10 times
Thanks Will do that after job 🙂
I found it. Wrong wire order. Green and Red was swapped