BEACON_INITIAL_CALIBRATION - Z-Home Fail
Hey guys,
I have a Core V4 500 IDEX and today I encountered a problem while homing.
With the command BEACON_INITIAL_CALIBRATION something is not working properly, X and Y are set correctly to home, but at Z the printbed moves against the printhead if I don't stop the process.
The red light comes on at the BEACON at about 10mm in front of the sensor, but nothing else happens. I have tried this several times and it is the same every time.
Does anyone have any idea where the fault could lie?
Solution:Jump to solution
Ok, solved the problem, the plug from the BEACON was probably not inserted correctly. Now everything works
1 Reply
Solution
Ok, solved the problem, the plug from the BEACON was probably not inserted correctly. Now everything works