can/should I try to improve this with kapton tape?
Since replacing the Eva 3 with the RR Toolhead and using a beacon probe, I find that the z offset is tuned well for the center of my bed but closer to the edges it doesn't stick. In particular, I noticed this when attempting to do an EM calibration (with the 9 blocks) for a new filament. I thought maybe I could improve my mesh with a little bit of kapton tape. Good idea? Bad idea? (with the 9 blocks).
2 Replies
the peak-to-peak measurement varies a bit, up to .215 mm (giver or take a um)
0.215 on a 400 is about nothing
you can do it if you want. but there is no point