VAOC webcam stream not found
I have a problem where the VAOC cannot stream at all.
I have followed the steps in the commisioning guide.
18 Replies
@miklschmidt Anything that you can guide me in the direction of??
Ratos-Debug.zip please
Hope this works??
everything looks corrrect in the config
make sure the cables on the camera are connected in the correct way. It happened to me when I frist assembled it (180 degrees rotation). That may not be the cause but just to make sure, please, check it
Just checked, it is correctly connected, I tried and turned it 180 degree just to be sure. no awail.
Tried with a different camera module too, just to be sure (I have 2 more IDEX printers that needs assembling and 6 more to come....
Tried with a complete 3rd module and cables, no luck there either
Can you plug the cam into a computer and check if there any image? Or adding the cam into mainsail
How do I add it to mainsail??
Webcams | Mainsail
In this tab you can connect mainsail with different webcam streamers. Some of the webcam clients are provided by Crowsnest (Webcam streamer wrapper from the Mainsail-Crew).
top right corner
I'm unsure what to do about it.
It will not show anything, not any of the cams..
I'm unsure what to do about it.
It will not show anything, not any of the cams..
try ssh and send ls /dev/v4l/by-id
the one finishing with index0, copy the device id and paste in crowsnest.conf
something like this
Nothing 😦
It feels really sad and time consuming now..
No answer from RatRig either
If nothing shows, there is something wrong with the small board.
And give them time. They will answer
It shows the adress and it sees the board, but not the feed.
And it's the same with two other boards and camera combinations
If it shows the device, then it is the camera module, not the small board where you connect the usb cable.
Really wierd that it is exactly the same with 3 different devices
I kinda insist on the assembly. It is a but tricky with the markings. They are very small
I'll have a try again tomorrow, I'm very much sure that at least one of them is assembled correctly.
I'll try and shut everything of tomorrow and switch to another module and cam.
I'm pretty tired of the IDEX and the pain to get it running is still not worth it in my opinion.
The pei ting profiles is way off too and the shaper calibration is a mess...
For me this is still too much hassle for a full release and is more alpha or beta..
Problem solved!
I reinstalled RatOS and updated crowsnest FIRST and everything works 💪