VCore4 IDEX Belt Tensioning - Should Mount Hybrid?
I'm working on going through the IDEX commissioning guide and seem to have everything complete. I am now looping back around to perform the standard commissioning guide. In what order should I do the tensioning? It mentions tuning the CoreXY belts first, and then adding and tuning the hybrid belts. However, during the IDEX commissioning guide, one issue I ran into was that the z-tilt cal did not work. Based on reading a couple of threads, the problem was that the hybrid belts need to be mounted for the IDEX machine to work properly for the commissioning, so I mounted the hybrid belts.
Now that im coming back to belt tuning, am I supposed to remove the hybrid belts and perform the tuning, even though I have the IDEX build, and then reattach the hybrid belts and continue tuning? If so, does this change any work I've done up to this point on the IDEX commissioning steps?
Solution:Jump to solution
ignore the manual on that part - you need the hybrid belts mounted in order for the tollhead to move correctly
1 Reply
Solution
ignore the manual on that part - you need the hybrid belts mounted in order for the tollhead to move correctly