No match for TMC5160 v1.3 (not pro) in configurator.
I'm upgrading to 2.1 on a slightly older printer with Octopus Pro H723 1.1 using tmc5160 v1.3. In the configurator, I'm not sure which profile to select since I can't find the exact match. Also, motors are OMC 17HS19 2004s1, will the LDO 2004AC profile work?
Solution:Jump to solution
You can select the T or Pro. Since you will not change voltage to 48V, the config is the same
2 Replies
I selected tmc5160T Pro and it seems to work. The control board jumpers are setup for SPI mode since the non pro drivers don't support SD. Any advice appreciated.
Solution
You can select the T or Pro. Since you will not change voltage to 48V, the config is the same