Vcore 4 IDEX 500mm bed banana...
Just finally got my printer together, imo it was all square when building. Was built on a glass table and measured corner to corner where possible. I've done everything up to BEACON_RATOS_CALIBRATE then scanned the bed.
I see a lot of people with a similar problem but this seemed like the worst. Not sure what to do 😦
9 Replies
that looks like you must to take a little bit up the right back profile corner mount (wher is the motor mount bracket), that is in commisionig guide
Start with rotating rubber foot in the far right corner. After corners settled you can pull gantry a bit upwards that will square this bow along X
Don’t mess with the frame yet
upwards how? Thanks for the help going to try again tomorrow
Ok, i adjusted the back right foot and did a few bed meshes. In the end i put the foot back all the way into the frame like it began, i pulled the x axis slightly up, tested, went the other way. So i pushed it back down a little and now i have this.
Waiting to see whats recommended to do next. Thanks for helping people
Feet are still uneven, adjust only one at a time and see which direction the mesh changes and which corner, sometimes it’s counterintuitive
And if no luck then you can try method from documentation but again one corner at a time at small adjustments
Which foot do you recommend i start with? Im reluctant to start messing with the quick connectors.
At the back, rotate left and check which corner corresponds and which direction
the highest point on bed mesh corresponding (X0 Y500) for back left corner the lowest bed mesh corner (x500 y500) corresponding for back right,
it should but I think it was one time they acted as inverted, maybe it wasn't leveled enough at that time