beacon 3.1 wrong offset
hi
I have retrofitted a beacon to my ratrig v3.1.
Now I have the problem that ratos still uses the x and y offset from the super pinda.
When I start the z tilt, it is the points from the super pinda and when I do the heightmap calibration, it always moves too far to the left and slightly touches the x end stop.
I have already reinstalled ratos extra but the problem is the same.
The offset is entered correctly in beacon.cfg
Because it uses the position from the super pinda, the first layer is also not correct
newest Ratos Version 2.1
Can someone help me?
4 Replies
Put this in the overrides:
Change the values according to your setup, these are for my 400.
ok that works
but something still doesn't seem to be right, the first layer is not good.
no idea what the problem is
Why do you believe it is using superpinda offsets?
I think I'm having the same issue with my setup as well (without using the overrides above)