Column not working.
The right most column on the left half of my corne just stopped working. This nice nano was already replaced for a similar issue by @Mike , but seems to be happening again.
6 Replies
It sounds like you're experiencing a hardware issue, likely related to the soldering of the nice!nano or a short circuit. Here are some steps to troubleshoot the problem:
1. Check the Solder Joints: Inspect the solder joints on the nice!nano and the PCB for the rightmost column. Ensure that the pin is soldered properly and there are no cold joints.
2. Look for Shorts: Use a multimeter in continuity mode to check for shorts between the pins. A short can occur if solder bridges are present.
3. Identify the Pins: Refer to the schematic for your Corne to identify which pin on the nice!nano corresponds to the rightmost column. This will help you focus your inspection.
4. Reflow Solder: If you find any issues with the solder joints, reflow the solder or add a bit more solder to ensure a good connection.
If you've checked all of these and the column is still not working, it may be worth considering replacing the nice!nano again, as it could be a recurring issue. If you need further assistance, feel free to ask!
My kit is using the no-solder options.
I tried re-flashing my firmware. Didn't work. Unsure where to go from here. @Mike Do I need another nice nano? And how can I make sure this doesn't occur again.
I have a backup IRIS, but without it, I wouldn't be able to type 😅 until this was resolve.
Do you have the premium aluminum case?
No, it’s the plastic 3D printed case.
Can you please DM your order number to me?
Sent