Pi has Problems to flash after reinstallation

Hi! Vcore 4 Stock Setup, was Up and running - Made the mistake to update components without updating ratos First (was shown as faulty and couldnt be recovered, also i got the resonance shaker error w newest Klipper) So i thought im smart and i'll reflash the Image. Pi boots Up and gives me 4 Green blinks So something not workig out. Normal pi Image flashes with the pi. Tried also with USB disconnected Also i copied the .img from the .XZ to my Desktop before flashing since i had faulty images when using balena to direcltly. Sandisk 32gb Card How do i recover from here? Thanks ahead!
Solution:
My Bad i think I found the issue. I loaded the armbian ISO Not the Raspberry one..
Jump to solution
16 Replies
TheTik
TheTik2mo ago
Does balena successfully write the image or does it fail the verify?
ben_ro.
ben_ro.OP2mo ago
When i copied the img from XYZ to Desktop it verifys, when flashing from XYZ direclty it fails
TheTik
TheTik2mo ago
sorry, I'm not sure what XYZ is
ben_ro.
ben_ro.OP2mo ago
My Bad, XZ, the archive the image is compressed in
No description
TheTik
TheTik2mo ago
Are you uncompressing the file before flashing? *.xz is like *.zip, you need to uncompress it first
ben_ro.
ben_ro.OP2mo ago
Yes thats what i ment!:) i copied the img to my desktop so it should be uncompressed at that point
TheTik
TheTik2mo ago
So you have a *.img file, not a *.xz file, correct?
ben_ro.
ben_ro.OP2mo ago
Yes!
TheTik
TheTik2mo ago
Try an older version of balena. A lot of people have had problems with the latest. Search in here and you'll see what is recommended. I unfortunately have to leave for now, good luck!
ben_ro.
ben_ro.OP2mo ago
Thanks im also on my way home allready (printer is at my workplace) so no hurry:)
bbaydar
bbaydar2mo ago
I used Rufus to write the image. Etcher woudl always error on the verify
MDFPereira
MDFPereira2mo ago
Are you using the same card? If so, did you remove both partitions with disk management? And use both rufus or rpi imager. Balena has bugs, yet (I hope they correct it)
ben_ro.
ben_ro.OP2mo ago
I used the same Card, yes, cleared all partitions, formatted in fat32 8kb I'll try another imager
ben_ro.
ben_ro.OP2mo ago
Hi! So thats the Error code my raspy shows
No description
Solution
ben_ro.
ben_ro.2mo ago
My Bad i think I found the issue. I loaded the armbian ISO Not the Raspberry one..
MDFPereira
MDFPereira2mo ago
That prevents from loading the correct config. Device tree, etc.

Did you find this page helpful?