Regular toolhead disconnection

It could be T0 or T1, I have experienced the various crash from both Toolhead. My setup is that I lengthen the USB cable using a CLIFF Connector feedthrough connector to connect to a remote control box. cable length is 4m. I have a USB hub comming that can be powered I plan to have it on the printer, and bing powered by a 24V power rail. hopefully it can sort the issue. @Rubino25 mentionned it could be caused by the PTFE tube. my printer is on the floor carpet. I am not sure if all of this create some ESD and disconnect the toolhead. I might find a coffe table to support the printer
0 Replies
No replies yetBe the first to reply to this messageJoin

Did you find this page helpful?