Error evaluating 'gcode_macro _START_VAOC:gcode
Error evaluating 'gcode_macro _START_VAOC:gcode': jinja2.exceptions.UndefinedError: 'extras.gcode_macro.GetStatusWrapper object' has no attribute 'z_offset_probe'
I started to get this error after updating to v2.1.0-RC3-20-g90dce855. I had this posted in the IDEX channel but I thought that I better start a thread here since the issue continues.
@Helge Keck had me try sudo bash ~/ratos-configurator/configuration/scripts/ratos-update.sh
which I did, rebooted, refreshed updates but nothing updated seems like it all already is up to date. printer.cfg has entries for z_offset_probe already so not sure where else to check in reference to the error code.
Solution:Jump to solution
put it back into the printer.cfg, restart klipper and then send me again the debug.zip file please
19 Replies
debug.zip please
Here you go
I didn't think that you would still be working on here, you need to get some rest!
there is no z_offset_probe in the printer.cfg
It was there, I just reran the setup wizard prior to posting.....
You are right, cna I just paste it from my last config backup?
well, its difficult to debug something without the correct files
š
You see it was there in the screenshot š
Solution
put it back into the printer.cfg, restart klipper and then send me again the debug.zip file please
standby...
Well crap now it works, it just wanted me to look foolish š
lol
Sorry to be that guy, I appreciate you!!!!
all good, probably jsut a copy and paste error, happens to all of us
I did notice that after I ran the command line, rebooted and reran the setup wizard that my main board and toolhead boards wanted updated so there was something hung that I didn't notice.