Failed homing of tool heads on V-Core 4 IDEX 500
When homing T0 tool head goes to the correct position but does not move back causing the error. Also T1 tool head moves in the incorrect direction after the T0 tool head triggers the end stop. I was attempting to follow the idea commissioning guide but the commands do not seem to work for setting the dual carriage.I have double checked the configuration of the motors and they seem correct. Is there a setting that needs to be adjusted in the configuration or did I just miss something?

Solution:Jump to solution
So I after going throught the configurator many times, it deleted the VAOC setup code from the printer.config file. After I copied the code back into the printer.config file I was able to continue through the guide. I also found that the T1 end stop had gotten smashed and was stuck.
2 Replies
It also seems my end stops are triggered for both the dual carriage and Z.

Solution
So I after going throught the configurator many times, it deleted the VAOC setup code from the printer.config file. After I copied the code back into the printer.config file I was able to continue through the guide. I also found that the T1 end stop had gotten smashed and was stuck.