v-core 4 idex
just finished assembly, going through the commissioning and the tool boards are giving a ADC out of range (448.742 not in range) have rapido hotend 2 and ebb v1.2 for both :vc4:
8 Replies
Sounds like the extruder has the wrong thermistor set
Did you choose PT1000 in the configurator?
Yes I did my good Tik. Followed along with the instructions etc.
Then I'd triple check the connection between it and the toolboard.
I'm on my phone right now but you can add a line in the
[extruder] section to change the max temp (don't remember the exact name) to something like 500 temporarily. Then use a heat gun or hair dryer to verify the temp readings change
If they don't change, then there is a short or open circuit to the thermistor.Oooooo that’s a neat idea! I like it! I will do so when I get back to work! Thank you so much! And I will let you know what I figure out
This Picture in the Guide is the problem. so the RAPIDO 2 UHF that ratrig supplied in the kit the wires are red and blue, but the thermistor is blue and the power is red... in this picture the power is blue and the thermistor is red.... I am ashamed of myself.
I could definitely understand being confused with that. Glad you found it! Did you re-terminate the ends and get it to work?
it's working now! 2 new issues now! yay!