mcu 'mcu': Unable to connect
I got this error this morning when starting my Vcore 500. I'm seriously a novice, so don't know where to start troubleshooting. I did update my RATOS Configuration Repository last night and seemed to restart OK, but didn't really monkey with it. Could that be a cause and if so, how do I go back to the previous config? Thanks,
Solution:Jump to solution
Just fyi for those that have the same issue, I ended up flashing a new SD card and reloading into the raspberry pi and going through updates again.
3 Replies
OK, this comes up on the BTT, so I think it is related to my update last night. Any idea how to re-update thst load or revert to the previous load?
Solution
Just fyi for those that have the same issue, I ended up flashing a new SD card and reloading into the raspberry pi and going through updates again.
New load with RatOS2.1.0 RC2 worked again, followed the system updates starting with the RATOS ones in the configurator and it got hung up on this. Went back to the same MCU failure. Will reflash back to the 2.1.0 RC2 and not update.
