Z-Tilt Calibration - Gantry crash into endstop every time
Hey, build up the V-Core 4 500 Idex and calibration makes problems. The Gantry crash into the endstop while Z-Tilt homing.
Normal Homing is working very well.
23 Replies
please share your debug.zip file
Here we are - i repeat the procedere again. it variate sometimes what he do. But on Z-tild it don't stop on Y-endstopp. It bumps full speed to the end until it goes on block
the config looks normal
i assume you have some mechanical issues
the toolhead should not move to that position at all
have you selected the perfromance mode in the ratos configurator motor settings?
i think not
please enable it
i assume you had some motor skips bc you still have been in training wheel mode
the motors didnt had enough power for the z tilt moves that are faster than the homing moves
okay, top. will try it directly
if it still doesnt work please make a video where i can see how the toolhead moves
from the homing and z-tilt procedure
Normal Homing
stop
after homing y it doesnt seem to move to the center of the build plate
can you confirm this
confirmed
it stays in front of the bed
please check your motor pulleys, if they are correectly tightened against the motor shaft
the motor shaft has a flat side, one of the grub screws needs to sit there
ok, check it now
stop
stop
you forgot to add the y belts
no wonder it doesnt work
I follow the build manual 😵💫 it’s one of the last steps?
the manual says for Hybrid do not attach the y belts, but this is a idex
confused 😣 okay - will put them on
ill make sure it will be clearer in the build guide
jsut add the y belts and it will work
Good to have support here 🙏 I will add them and report
should i disable performance mode ?
i think its safe to keep it, your motion system seems to work
i jsut see that the build guide mentiones it already
this is what confuses - Do not install before …. and in commission guide the steps are homing and z-tilt
at my fault … 🙋♂️ will fix it
Now its working as expect. Thanks a lot for your help !