Cant move carrige on idex
i was trying to do these steps
X Stepper motor directions
1. Run M18 in your mainsail console.
2. Move both toolheads manually to the middle of the build plate (leaving at least 100mm of spacing between them)
3. Run SET_CENTER_KINEMATIC_POSITION
4. Run SET_DUAL_CARRIAGE CARRIAGE=0 to activate T0
**
Then after that i cant move carrige bc there is and error message.
1 Reply
Found it
Easy solution just try stepper_buzz and look for not working stepper. Mine problem was that there is no motor2 and its the one with empty driver. I changed it to motor4 and now its working